1.9" Halo Lime

Our 1.9" Halo Ring Inserts are a fantastic way to add a bit of color to your Locked Up RC wheel set.

Like our popular "Backlight Glow Rings", these inserts are sandwiched between your existing bead lock ring and wheel.

These Ring Inserts protrude from behind your ring to offer a various amount of color depending on setup.

For example, the inner diameter on these Plain Ring Inserts is 34mm.

So when used with an Agile ring (ID 39mm), you see about 2.5mm of color all around.

These inserts can be used with ANY of our 1.9" bead lock rings but we feel they look best with our more open designs like the Agile, Demon & Sever.

What is included:

1x 1.9" Halo Lime Ring Insert 

Specs:

- FDM printed with PLA

- Matte Finish

~ 41mm outer diameter

Printed parts may require you to do some final deburring. Just like plastic parts from a parts tree.

So, BEFORE installation, please check the piece for any burrs that need to be removed.

To install:

1. Remove your outer bead lock ring and lay your wheel face up.

2. Place the Insert Ring into the wheel so that the side with the "flange" is at the top.

3. Reattach the bead lock ring and tighten to gently push insert into place.

4. Verify that the bead lock ring is flush against the wheel (check from the sides).

 (If the ring is not sitting flush, check for alignment and burrs.)