Locked Up RC is happy to present our solution for those that are looking for a stronger, reasonably priced, replacement rear axle shaft for their SCX10 II (aka: SCX10 2)
OT shafts offer several improvements over stock shafts:
1. Torsional tensile strength rating of over 160in/lbs*. That is over 33% more than a typical stock shaft, which suffers destruction in the 120in/lb range.
2. We thread the end of the shaft several extra turns vs stock. So if you are trying to narrow up your rig with narrow hex hubs and our .185 SLW hubs you can run them with less or no washers behind your wheel nuts.
3. No "hat" near the tangs to more easily pass through axle tubes and past mounting hardware (like Gunnar tubes and CMS kit hardware).
4. A slightly thicker "tang" for a tighter fit, even with a stock locker.
Even with these improvements these are a direct replacement requiring little to no modifications to a stock vehicle.
You can expect a direct slide in fit with stock lockers.
If you are running an aftermarket housing, like a Pro 44, these may NOT work.
If your shafts are a tight fit with your locker, we suggest using our
Copper Anti Sieze Grease during installation.
This will help with shaft removal after extended periods of use.
What's included:
-2x Shafts
-2x 4mm nuts
-2x 2x10mm HD pins
Hello, Guest! 
[ITEMPRICE]