0 item(s) in cart/ total: $0
Chassis & Drivetrain
Ascender Driveshaft Pinion Adapter
Review this item
Add to Wish List
Locked Up RC is happy to present our solution for those that are looking to bolt non-Vaterra driveshafts to their Vaterra Ascender.
These adapters replace the stock pinion shaft (VTR232072 partial) with one that includes a 5MM shaft output.
This will allow you run different length shafts for wheel base changes OR driveshaft upgrades.
Each adapter has a 2mm pin hole, which can be enlarged for big pins or used with our
Like our OT shafts, these adapters offer a torsional tensile strength rating of over 160in/lbs*.
You can expect a direct slide in fit with stock gears.
Fits front & rear axles.
Standard driveshaft installed:
M3x4 Extended Tip Set Screw (5)
Your Price: $2.49
OT Shaft - Ascender
Your Price: $21.99
Recently Viewed Items